3/14/2024 0 Comments Doom 3 pc screen tearing: The screen flashes once after switching to the discrete GPU-only mode in the NVIDIA Control Panel.: The primary monitor lost after resume from sleep or shutdown.: The system does not boot with two Samsung Odyssey G70A 28" monitors are connected to the GPU.Is there something to do to get the best of both ? ie lower usage and no tearing ? Apologies for the length, it is just that I am getting frustrated again GPU is RTX 2060, CPU is i7-9700 - running mostly ion High expect clouds and off screen caching (ultra) and terrain LOD 150. The GPU usage increases significantly to 90-100 % but then there is no screen tearing when panning. Use the in-game Vsync and limit to 20 or 30 FPS and set frequency of the monitor to 60Hz:.My GPU and VRAM usage remain low - around 60% (I am OK with 24 or 30 FPS) but I get the screen tearing. I limit FPS in NCP, set Vsync in NCP to off, keep frequency of the monitor at 144Hz:.I have followed the two approaches below, each with its problems: I am using a 144Hz 2560x1440 monitor for the game and have another 60Hz 1366x768 monitor for out-of-game charts etc. I have been following this approach (Vsync / limiter in game disabled, limit FPS in NCP and Vsync in NCP to off as you suggested) but I am experiencing screen tearing when panning inside the cockpit.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |